Service
Support hotline
136 6332 7859
Service
Current: Home >> Service > Precautions

Conveyor belt should be kept clean during transportation and storage, avoid direct sunlight, rain and snow immersion, and prevent contact with substances that affect rubber quality such as acid, alkali, oil, organic solution, and 1 meter away from heat source.
The temperature in the warehouse should be kept between -15 °C and +40 °C during storage, and the relative humidity should be kept between 50% and 80%.
The conveyor belt must be placed in a roll during storage and should not be folded. It should be turned once every season during the placement.
Conveyor belt running speed should not be more than 5.0 m / s, transportation block size, abrasive material and low-speed when using fixed plow type unloading device. When the specified speed is exceeded, the tape life will be affected.
The relationship between the diameter of the drive roller of the conveyor and the layer of the conveyor belt, the matching of the drive drum to the drum and the requirements of the groove angle of the roller should be reasonably selected according to the design regulations of the conveyor.
In order to reduce the impact and wear of the material on the tape, the feeding direction should be in the running direction of the tape; the drop of the material falling onto the tape should be reduced as much as possible; the feeding port should avoid the roller or the roller directly above; The section should shorten the idler spacing and take buffering measures. In order to prevent the tape from being scratched, the contact part of the material blocking device, the blade cleaning device and the unloading device with the tape should be a rubber plate with a suitable hardness. Do not use a tape head with a cloth layer.
The following points should be noted when using the conveyor belt:
A. Avoid covering the roller with material, causing the rotation to be ineffective, preventing the leakage from getting stuck between the roller and the tape, paying attention to the lubrication of the moving part, but not the oily conveyor belt.
B. Strive to avoid starting with load.
C. When the tape is out of deviation, measures should be taken to correct it in time.
D. It is found that the local damage of the tape should be repaired in time to avoid expansion.
E. Avoid the tape being blocked by the frame, pillars or block materials to prevent breakage and tearing.
Joint strength retention rate:
A. Mechanical connection method: The buckle connection is equivalent to 28%-45% of the strength of the conveyor belt itself.
B. Natural vulcanization (cold bonding) bonding method: bonding with cold glue is equivalent to 40%-55% of the strength of the conveyor belt itself.
C. Thermal vulcanization (fusion) bonding connection method: mechanical heat vulcanization bonding is equivalent to 60%-80% of the strength of the conveyor belt itself.